Raider PRO RDP-SBBC20 User Manual page 20

20 www.raider.bg
properly installed.
Cleaning.
It is easiest to clean the trimmer immediately after mowing. After work, carefully clean the machine
with a soft brush and a cloth. Do not use water and / or solvents and detergents. Remove any debris
from the grass, especially the vents. Position the machine sideways and clean the cord area. Always
wear safety gloves! Remove any sticky particles with wood or plastic logs.
Always clean the trimmer thoroughly when leaving it for longer storage. Especially in winter.
FAULTS AND WAYS TO REMEDY THEM.
The table below shows symptoms of malfunctions and how you can help yourself if your trimmer stops
working properly. If you cannot find and correct the problem by following the instructions in the table,
contact a Ryder Authorized Repairer.
Charge the lithium rechargeable battery.
Remove the battery from the handle, press the button down to do this. Pay attention to mains voltage when
charging the battery! The mains voltage must match the data on the charger label. Appliances marked with
230V can also be powered with a voltage of 220V. The green LED will be switched. Squeeze the battery
into the charger.
See explanation table:
Red LED
Off
On
Off
If the battery can not charge, check the following:
• contact voltage
• makes good contact with the charger contacts
If the battery can not be charged again, visit an authorized RAIDER service center.
To make sure that the lithium-ion rechargeable battery will last longer, you must recharge it
immediately. You must recharge the battery when you notice that the power of the cordless tool is
decreasing.
16.2. Battery capacity indicator.
Press the button on the battery capacity indicator. It shows the status of the battery charge using 3
LEDs.
All 3 LEDs glow: The battery is charged
2 LED (s) are on: The battery has enough residual charge
1 LED is on: The battery is running low, charge the battery
All LEDs blink: The battery has completely broken down and defective. Do not use or charge a
defective battery.
Indicator status
Green LED Ready for use
The charger is connected to
On the mains and is ready for
use; there is no
battery pack in the charger
Off "Charging
The charger is charging the
battery pack "
On "The battery is charged
and ready for use.
Charging time for 2.0 Ah
battery: 60 min
Action:
Take the battery pack out of
the charger. Disconnect the
charger from
the mains supply."
Explanations and actions