Raider PRO RDP-SBBC20 User Manual page 19

19
To stop the tool, release the switch trigger.
The tall grass should be mowed in layers, as shown in FIG. D
Attention !!!
Protect the brush cutter from hard surfaces and injuries.
Angle and direction of cutting Fig. (E)
Replacing the spool:
. Switch off the brush cutter;
• Turn the machine upside down;
. Squeeze the lid of the cord head with its locking teeth. Remove the pulley and replace the cord with a
new one, not exceeding 2 meters in total length. The cord must be wound in a direction opposite to the
direction of wobble of the head. Put the reel in the base („bed") of the head, pull out some of the cord
to make sure that the reel is properly fi tted, and then insert the head cover, ensuring that it is securely
secured by the retainers.
4. PRACTICAL TIPS:
Observe municipal regulations for the time of day you can use outdoor machines. In some countries,
mowing is prohibited in the morning before 08.00, after noon between 14.00 and 16.00 in the evening
and after 22.00 in the evening, to protect citizens from unwanted noise.
Often the lawns are made up of grasses of diff erent varieties. Frequent mowing will enhance the
growth of these varieties, which form dense tufts and strong roots. If you rarely mow your lawn, you
will enhance and improve the development of tall grasses and weeds. The normal height of the grass
is about 4-5 cm. It's a good idea to plan your mowing frequency so that you can cut at most 1/3 of the
total grass height with one cut. If you do not water your lawn, do not mow the lawn less than 4 cm, as
it will be damaged if it is dried.
When operating in particularly harsh conditions, be careful not to overload the motor. When the motor
is overloaded, the motor speed drops and its noise changes. In this case, stop, release the power lever
(1) and adjust a higher cutting height. Otherwise, productivity will decrease and the machine may be
damaged.
When mowing near the edges, be careful not to attach any foreign objects to the trimmer.
Cutting performance depends on the density, humidity, length of grass, as well as cutting height.
Cutting performance decreases when the trimmer is switched on and off frequently during cutting. To
optimize mowing performance, it is recommended that you mow more often, increase cutting height,
and operate at a moderate speed.
SERVICE, MAINTENANCE AND STORAGE.
ATTENTION! Once the machine is switched off , the cord continues to rotate for a while! Before you
start working on the trimmer, wait until the motor rotates and the cord stops completely!
Never try to stop the rotation of the cord!
Always wear protective gloves when carrying out activities near the cord!
Follow maintenance procedures on a regular basis to ensure long-lasting and reliable use of the
trimmer. Check periodically for noticeable defects, such as loose or damaged knife and loose screw
connections. Make sure that the covers and safety equipment are in good working order and are