Table of Contents
Advertisement
2
Modified Deck
If the screw hits a nail
!
under the shingle, there are
a few solutions. Leave the
nail and use the rest of the
holes if possible, if not:
1. Remove the nail
2. Angle the driver to avoid
the nail
3. Use a 3mm steel drill to
make a hole.
Part D: Ensuring Proper Installation
1
Proper torque will vary based on the characterisitcs of the rafter and deck. It's best practice to tighten the wood
!
screws until the washer stops rotating. After completing process, make sure the Splice Foot X/XL is securely fixed.
You may verify that the screws underneath the deck panel are stained with butyl rubber. This indicates a good
flashing performance. Butyl should extrude from the sides of the mount.
13
Advertisement
Table of Contents
Need help?
Do you have a question about the Splice Foot X and is the answer not in the manual?
Questions and answers