Fuse Case
Disconnect battery cables at the battery.
Disconnect white lead wire of rectifier from engine
wire harness.
Check continuity between white lead wire of
engine wire harness and red lead wire of starter
motor magnetic switch "B" terminal.
1
1. White rectifier lead
1. Red magnetic switch lead
2. Starter magnetic switch
If no continuity is indicated, replace engine wire
harness and/or fuse.
BATTERY CHARGING SYSTEM
Removal and Installation
Before removing electrical parts:
•
Disconnect battery cables at the battery.
•
Twist and remove all spark plug leads.
Battery Charge Coil
Remove flywheel, screws, and battery charge coil.
Refer to COMPONENT SERVICING on p. 99.
005562
Rectifier and Regulator
Remove the screws securing the rectifier and reg-
ulator.
1
Disconnect lead wire connectors.
2
005563
1. Screws
2. Rectifier/regulator
Installation
Installation is reverse order of removal with spe-
cial attention to the following steps:
Check wire routing. Refer to WIRE ROUTING on
p. 229.
ELECTRICAL
4
005564
2
1
005565
73