Notify Alarm Via Modem; Alarm-On Delay; Excitation Warm-Up Delay; Channel Alarm Settings - Microedge Instruments iLog Series User Manual

Compact data loggers
Table of Contents

Advertisement

Notify Alarm via Modem

This field specifies if the alarm notification is been sent out via Modem when in alarm state.

Alarm-On Delay

This filed specifies a time delay before sending out alarm notification if there is an alarm.
This applies to both terminal strips and the dial-out command which is sent out via
communications port.

Excitation Warm-up Delay

This field specifies how much delay will be put after the excitation terminal is activated and
before the logger is taking the sample.

Channel Alarm Settings

This table specifies how each channel controls alarm state by:
Alarm Enabled:
Low & High Alarm:
iLog Data Loggers User's Manual
Check this field to associate this channel to the alarm state.
These fields define the alarm thresholds. If the reading is beyond
these thresholds, the alarm is triggered.
Page 50/63

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the iLog Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents