2. The logger is now in Start Delay mode. When you need to activate the logger, press and
hold the Activation button on the logger. When you see the status LED starts to flash
release the button. The logger is now activated and is recording data.
Note: The activation button cannot be further activated once the logger has started the new
session.
Reset Device
The on-board activation button can also be used as a reset button in case the data logger does
not respond to the PC communications.
iLog Data Loggers User's Manual
Push to activate new logging session
Field Activation
Page 25/63
Need help?
Do you have a question about the iLog Series and is the answer not in the manual?