Olympus DP21-SAL Instructions Manual page 69

Installation of U-HSEXP
}The U-HSEXP is composed of the U-HSEXP switch (fixed by magnet) and circular iron plates (adhesive). Two circular
plates are provided, with one of them intended for use as the spare.
3
2
Downloaded from ManualsNet.com
1
CAUTION
search engine
1. Attach the switch @ on the center of the circular plate ² by means of
magnet.
Do not remove the backing sheet of the circular plate until the final fixing
position is decided.
2. Decide the final fixing position that is most convenient for controlling the
switch from the area 3 (indicated by
adjustment knob on the left or right.
}Please note that if the attaching position of U-HSEXP is too close to the
coarse adjustment knob, it may touch the pre-focusing lever.
3. Clean the final fixing position with absolute alcohol, remove the backing
sheet from the round plate and apply it securely on the final fixing posi-
tion.
If there is an article with magnetic field near the U-HSEXP,
equipment failure or malfunction may result. So do not let such
an article as listed below come close to the U-HSEXP.
· PC
· Mobile phone
· Clock/watch
· Credit card
· Bank card
· Floppy disk, etc.
}It cannot be recorded by the shutter switch. Use the hand switch D21-HS
to start/finish recording. (p.25)
DP21-SAL
in the figure) near the coarse
66