Test Run - Grizzly G0623X Owner's Manual

Connect incoming power wires to terminals
shown in Figure 50.
Note: If using a phase converter, connect the
manufactured power leg to the #2 terminal to
prevent damage.
1 2
R S
Figure 50. G0623X3 power connection termi-
nals.
4.
Tighten strain relief on bottom of connec-
tion box against power cord (G0623X or
G0623X3, 230V/220V) or conduit (G0623X3,
440V)—not directly against power cord or
wires—then close cover. Leave a little slack
in wires inside box.
-34-
3 4
T
Ground
Incoming
Power Line

Test Run

After the machine has been connected to the
power source, the machine MUST be test run to
make sure all the controls and safety components
function properly before the machine is placed
into regular operation.
It is extremely important that all steps in this sec-
tion be followed very closely, in the order given,
to ensure that the safety features are tested cor-
rectly.
Before beginning the test run, review the power
controls shown in Figure 51 and Identification
on Page 3.
Front
STOP
Button
Figure 51. Main power controls.
If the machine does not operate as stated
in this section, review the Troubleshooting
section on Page 69. If you need additional
help, call Tech Support at (570) 546-9663.
DO NOT place a machine into regular opera-
tion if you suspect that it is malfunctioning,
or serious injury could occur.
Model G0623X/G0623X3 (Mfd. Since 05/22)
ON Button