Outfeed Table - Grizzly G0623X Owner's Manual

9. Countersink holes you drilled in Step 7 (see
Figure 115), so heads of mounting screws
can be recessed into table insert when
installed.
Cutaway View
of Drilled Hole
⁄ " Hole
7
32
for Screw Threads
Figure 115. Countersinking mounting holes.
10. Install blade you will use to cut insert, making
sure blade flange is used on front of blade
behind arbor nut, then lower blade fully.
11. Test fit new table insert in table, then sand
corners or trim ends as necessary to get a
precise fit.
12. Mount new table insert into table and check
to make sure that it is flush with top of table.
If necessary, remove insert and sand top of it
down until it will mount up flush with table top
(see Figure 116).
Figure 116. New zero-clearance table insert
installed to be cut with a dado blade.
13. (This step only for standard blades.) Use
bandsaw or jigsaw to cut slots or notches
that will allow riving blade to be installed with
minimal open space around it. If you plan to
use scoring knife, do the same for that blade.
(We do not recommend using the scoring
blade to cut the slot in the insert because the
adjustment screw is inside the cabinet).
-62-
⁄ " Hole
13
32
Countersink
for Screw Head
New
Table Insert
14. Close cover over blade and move sliding
table to center of saw.
15. Connect saw to power, start motor, and slow-
ly raise blade into zero-clearance table insert
(see Figure 117) only as high as you intend
to cut with insert.
Zero-clearance
Table Insert
Slot for
Riving Knife
Slot for Scoring Blade
Figure 117. Zero-clearance table inserts for
dado and standard blades.

Outfeed Table

One of the best accessories for improving the
safety and ease of using a table saw is simply
placing a large table (outfeed table) behind the
saw to catch the workpiece.
Figure 118. Example of outfeed table.
Model G0623X/G0623X3 (Mfd. Since 05/22)
Dado
Blade
Standard
Blade
Outfeed
Table