Cap Screw M10-1.5 X - Grizzly G0623X Owner's Manual

40. Attach hose support to large extension table
as shown in Figure 44.
Hose
Support
Lock Washer
10mm
Lock Nut
M10-1.5
Hose
Support
Cap Screw
M10-1.5 x 25
Figure 44. Attaching hose support to large
extension table..
DO NOT operate this saw without an ade-
quate dust collection system. This saw cre-
ates substantial amounts of wood dust while
operating. Failure to use a dust collection
system can result in short and long-term
respiratory illness.
Minimum CFM at 4" Dust Port:
Minimum CFM at 2 ⁄
1
2
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine
the CFM at the dust port, you must consider
these variables: (1) CFM rating of the dust col-
lector, (2) hose type and length between the
dust collector and the machine, (3) number
of branches or wyes, and (4) amount of other
open lines throughout the system. Explaining
how to calculate these variables is beyond the
scope of this manual. Consult an expert or pur-
chase a good dust collection "how-to" book.
-32-
Flat Washer
10mm
Large
Extension
Table
400 CFM
" Dust Port: 150 CFM
41. Secure 4" dust hose to dust port located
under saw table and 2
guard (see Figure 45).
Figure 45. Dust hoses attached.
42. Run 2½" hose over hose support, as shown
in Figure 46.
Figure 46. Dust hose placement on hose
support.
Tip: Connect saw to a single dust collection
branch line, using optional accessory shown
in Figure 47.
4" Dust Hose
T20559
2 ⁄ " x 4" x 4"
1
2
Y-Fitting
Figure 47. Optional accessories for consolidating
dust lines.
Model G0623X/G0623X3 (Mfd. Since 05/22)
⁄ " dust hose to blade
1
2
4" Hose
2 ⁄ " Hose
1
2