Inventory - Grizzly G0623X Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Crate Inventory (Figure 4)
A. Table Saw Body ......................................... 1
A
Figure 4. Table saw.
-18-
Inventory Items (Figure 5)
B. Large Extension Table ............................... 1
C. Small Extension Table ................................ 1
D. Hose Support ............................................. 1
D
Figure 5. Extension table items.
Inventory Items (Figure 6)
Qty
E. Crosscut Fence .......................................... 1
F. Support Bar ................................................ 1
G. Crosscut Table ........................................... 1
H. Crosscut Table Support Leg ....................... 1
I. Flip Stops ................................................... 2
J. Lock Lever M12-1.75 x 55 ........................... 1
K. Flat Washer 12mm ..................................... 1
L. T-Nut M12-1.75 ............................................ 1
E
K
J
Figure 6. Crosscut table items.
Model G0623X/G0623X3 (Mfd. Since 05/22)
B
L
I
H
Qty
C
Qty
F
G