Understanding The Snmp Configuration Interface; General - GDC SX-3000 User Manual

2. SMS
1
6
1 For SNMP Manager IP
sent by typing in the IP Address , press the
2 For Trap Sending
the SNMP Manager. The trap will continue to be resent only as long as the error condition exists.
3 For System UpTime Threshold
NOTE: When Trap is On, a trap will be sent if the System UpTime exceeds the threshold value.
4 Activate the Trap by checking the small box opposite
NOTE: When Trap is On, a trap is sent if the SNMP Agent is started.
Deactivate the Trap by un-checking the small box next to SNMP Agent Start
5 Activate the Trap by checking the small box opposite
NOTE: When Trap is On, a trap is sent if the SNMP Agent is stopped.
Deactivate the Trap by un-checking the small box next to SNMP Agent Stop.
6 Check on the small box to enable SNMP Service.
SX-3000 Standalone Integrated Media Block™ User Manual

2.3.5.3. Understanding the SNMP Configuration Interface

2.3.5.3.1. General

Figure 15 SNMP Configuration [General Settings].
Address, indicate the IP address of the SNMP Manager where traps are to be
Interval, indicate the time interval in seconds after which a trap should be resent to
(days), indicate the threshold time in days.
- 32 -
+ or - button to insert multiple SNMP addresses.
SNMP Agent Start.
SNMP Agent Stop.
.
2
3
4
5
0
February 14, 2013