Heat Sink - HP ENVY 16 Maintenance And Service Manual

3. Remove each solid-state drive (3).
To install the solid-state drive, reverse the removal procedures.
NOTE: Solid-state drives are designed with a notch to prevent incorrect insertion. When installing, make
sure the thermal pad is attached to the solid-state drive covers before replacement.

Heat sink

To remove the heat sink, use these procedures and illustrations.
Table 5-6 Heat sink descriptions and part numbers
Description
Heat sink for use in 80 W models
Heat sink for use in 60 W models
Thermal gel
Thermal gel syringe
Thermal grease kit
Thermal grease syringe
Before removing the heat sink, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the heat sink:
1. In the order indicated on the heat sink, remove the four Phillips M2.0 × 3.5 screws (1) that secure the
heat sink to the computer.
40 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page 34).
33).
Spare part number
N13390-001
N13389-001
M81334-001
M81335-001
M28157-001
M28158-001
33).