Power Connector Cable; System Board - HP ENVY 16 Maintenance And Service Manual

Reverse this procedure to install the display panel.

Power connector cable

To remove the power connector cable, use this procedure and illustration.
Table 5-9 Power connector cable description and part number
Description
Power connector cables
For 150 W models
For 200 W models
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the heat sink (see
5. Remove the fan assembly (see
6. Remove the display panel assembly (see
Remove the power connector cable:
1. Make sure the power connector cable from the system board is disconnected (1).
2. Remove the power connector cable from the computer (2).
Reverse this procedure to install the power connector cable.

System board

To remove the system board, use these procedures and illustrations.
44 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page 34).
Heat sink on page 40).
Fan assembly on page
Display assembly panel on page
33).
41).
43).
Spare part number
N13377-001
N13378-001
33).