Solid-State Drive - HP ENVY 16 Maintenance And Service Manual

5. If the WLAN antenna is not connected to the terminal on the WLAN module, install a protective sleeve on
the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WLAN module.

Solid-state drive

To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-5 Solid-state drive descriptions and part numbers
Description
2 T, M2 2280, PCIe-4 × 4, NVMe value, three-layer cell (TLC)
1 T, M2 2280, PCIe-4 × 4, NVMe value, TLC
512 GB, M2 2280 PCIe-4 × 4, NVMe value, TLC
Solid-state drive thermal pad
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the solid-state drive:
1. Remove the two Phillips M2.0 × 2.5 screws (1) that secure each solid-state drive covers to the computer.
2. Lift and remove each solid-state drive cover (2).
Preparation for disassembly on page
Bottom cover on page
Battery on page 34).
33).
Spare part number
M52027-005
M16560-005
M17436-005
N13391-001
33).
Solid-state drive 39