HP ENVY 16 Maintenance And Service Manual page 56

4. Remove the heat sink (see
5. Remove the fans (see
6. Remove the display assembly panel (see
7. Remove the system board (see
Remove the speakers:
1. Disconnect the speaker cables on each side of the computer (1).
2. Remove the four Phillips M2.0 × 1.88 screws (2) that secure the speakers to the computer.
3. Remove the two Phillips M2 × 3.5 screws (3) that secure each tweeter to the computer.
4. Remove the speakers from the computer (4) .
5. To replace the speakers, insert the speaker wires into the retention clips (1). On the right side, pull the
tab to release the conductive tape (2), and install the tape on the metal bracket (3). Install the four
Phillips M2.0 × 1.88 screws (4) to secure the speakers to the computer. Install the two Phillips M2 × 3.5
Heat sink on page 40).
Fan assembly on page 41).
Display assembly panel on page
System board on page
43).
44).
Speakers 49