HOMCOM 821-020V80 Assembly & Instruction Manual page 11

Humidity adjusting the order of 30% to 80% - 75% - 70% - 65% - 60% - 55% - 50% - 45% -
40% - 35% - 30%;
Time set to 00, press this key, display 00 and blink, and then press this key again every time, from
24-23-22-...... The value of -00 keeps repeating -1
Child-lock（Lock）
When the machine is turned on, press the button for 3 seconds to open/close the child lock
function. When the button is turned on, the indicator light of the child lock is on. The indicator
light of child lock is off; After the child lock function is opened, the child lock function will be
cancelled automatically as long as the shutdown or power failure occurs
5.4 DRAINAGE
There are two ways of removal collected water produced by the unit.
A. Manual draining: Empty water tank by manual.
B. Continuous draining: Use gravity to drain condensate water by attaching a drain hose.
5.3.1 EMPTYING THE WATER TANK
The water tank built in unit will fill up and shut the unit down once it is full. It will run again once you empty the
water tank and installed properly.
1) When the tank is full, The unit will make a buzzing sound, and the "Water Full" light will turn on.
2) Press the POWER button to turn off the unit.
3) Pull on the water tank and simply slide out of the body of the dehumidifier.
4) Empty the water into an area with a drain or outside.
5) Clean the inside of the tank as well as the outside.
6) Replace the empty tank back into the unit.
7) Press the POWER button to resume operating.
8) If the Water Full light does not extinguish, check that the float is correctly in place.
10