Table of Contents
Advertisement
ERROR MESSAGES
Error Codes
Computer receiving error signal
Er1
up to 15 seconds.
Er3
Low Voltage
1. Motor Cable become loose
Er5
2. Motor is blocked
3. Motor damaged
Power IC board not receiving
Er7
signal.
SAFE
Safe tether key protection.
Cause
17
Solution
1.
Restart the power, and retry after
1 minute.
2.
Ensure the sensor cable is
connected perfectly.
3.
Signal cable or computer IC
board damaged, discontinue use
and contract with your local dealer
for support.
1.
Restart the power, and retry after
1 minute. Check if the input
voltage is lower. Use when
voltage is normal.
2.
Signal cable or power IC board
damaged, discontinue use
and contract with your local dealer
for support.
1.
Restart the power, and retry
after 1 minute.
2.
Check the motor cable, make
sure it is connect perfectly.
3.
Check the motor quality, make
sure there is no visible damage.
4.
Ensure the running belt is
throughly lubricated.
5.
Motor or power IC board
damaged, discontinue use and
contract with your local dealer
for support.
1.
Restart the power, and retry after
1 minute.
2.
Ensure the sensor cable is
connected perfectly.
3.
Signal cable or power IC board
damaged, discontinue use and
contract with your local dealer
for support.
1.
Reinstall the Safety Tether Key.
2.
Restart the power after 1 minute
and install the Safety Tether Key.
3.
Computer IC Board damaged,
contract with your local dealer for
support.
Advertisement
Table of Contents
