2: Installing A Security Tamper Switch; 3: Receiving Unit - Honeywell XLS140 Installation Manual

Applications
For bypass of security zones, use the DISABLE routine (covered in the Status Change section of
the XLS140 Operations Manual) for Security type devices.
WARNING:
!
Damage can result from incorrect wiring connections.
4.4.2 Installing a Security Tamper Switch
To wire the cabinet with a Security Tamper Switch kit model STS-1, refer to Figure 4.3:
1. Install the STS-1 Tamper Switch onto the side of the backbox opposite the door hinge, pushing
the switch through the opening until it snaps into place.
2. Install the magnet on the same side of the cabinet door as the lock. Push the magnet through
the opening in the door until it snaps into place.
3. Connect the STS-1 connector to J10 (Tamper) on the Control Panel.
Figure 4.3 Installing the STS-1 Security Tamper Switch
4.4.3 Receiving Unit
For applications requiring transmission of security alarm information to a central receiving unit, the
control panel may be connected via a UDACT to a compatible receiving unit (see the UDACT
Manual). For information on configuring the Receiving unit for Combination Fire/Security
applications, refer to the documentation for that control panel.
62
STS-1 mounting location
(side opposite of door hinges)
XLS140 Installation Manual Form Number 95-7673-3 P/N 51927:C 12/06/2005
Fire/Security Applications
Connect to
J10 "Tamper"