Troubleshooting - Xerox FD70 User Manual

®
Xerox FD70 Scanner
9. Rotate the locking tab into the slot in the scanner. Push on the lever until it clicks in place and
locks the roller in the scanner.
The lock will "click" into place when it is secure. However, if it does not rotate easily into the
housing, make sure the flange is properly seated in its latch.
10. Rotate the belt back down into place. The cover will not close if the belt is in the wrong
position.
11. Lift the roller cover and carefully push it closed to lock it in place. Make sure everything is
aligned properly and the cover is fully closed. If the cover is not fully closed it will break during
scanning and damage the scanner.
12. Close the scanner when you're finished.

Troubleshooting

Problem: The scanner won't scan. What's wrong?
Check for one of these possible causes:
Are the cables loose or not plugged in securely? Inspect the cable connections. Make sure
•
the cables are plugged in securely.
Is the scanner's status light on? Turn on the scanner's power. If the status light doesn't
•
come on, plug the power supply into another electrical outlet. If you are using a UPS battery
back-up or power strip, try plugging the scanner directly to a wall outlet.
44
Maintenance
Scanner User Guide