Disabling Input Monitoring; Start Playback; Mixing The Playback Sound - Tascam HS-8 Owner's Manual
8 channel audio recorder
Hide thumbs
Also See for HS-8:
- Software manual (13 pages) ,
- Release notes (4 pages) ,
- Software manual (4 pages)
Table of Contents
Advertisement
4 − Recording and Playback
If the take is not currently in the selected project, a
Selected take is in another project
message appears.
Message shown when the take is inside the project
Message shown when the take is outside the project
5 Touch the
button.
OK
When loading completes, the Home Screen reopens.
Disabling input monitoring
Turn input monitoring OFF for the channels (tracks) that
you are playing back. If input monitoring is ON for a
channel, sound will be input through the corresponding
input connector.
1 Touch the REC/MON button on the Home Screen to
open the REC/MON screen.
2 Touch the input monitoring buttons for the
channels that you want to play to turn input
monitoring OFF.
NOTE
You can also access the input monitoring buttons by pressing the
MENU key to open the MENU screen or by touching the CHANNEL
SETUP button to open the CHANNEL SETUP screen.
Start playback
Press the
key.
PLAY
Press the
key to pause playback.
PAUSE
Press the
key again to resume playback.
PLAY
Press the
key to stop playback.
STOP (RETAKE)
Press the
and
keys briefly to change the take.
Â
¯
While pressing the
key, press the
SHIFT
and
(
) keys to move between marks.
MARK ¯
¯
30
TASCAM HS-8
Press and hold the
pop-up
search backward or forward during playback. While
pressing the
NOTE
•
•
Mixing the playback sound
Use the internal mixer function to mix the recorded tracks
into stereo and output them to the
R/B (XLR)
1 Press the
2 Touch the
(
)
MARK Â
Â
NOTE
When in solo mode, PAN or 2Mix LVL knob cannot be selected.
(
) or
Ô
key, press and hold a
SHIFT
(
) key to search at high speed.
On the PLAY SETUP screen, you can set whether only the
currently selected take is played or whether all the takes within
the current folder are played. You can also enable and disable
repeat playback. (See "Playback settings (PLAY SETUP)" on page
45.)
Playback functions can also be used through parallel control.
, and
DIGITAL OUTPUT L-R (XLR)
key on the front panel to open the
HOME
Home Screen.
button on the Home Screen to
PAN/LEVEL
open the
page.
PAN/LEVEL
PAN knobs: Use these to adjust the left-right position
sent to the stereo bus. Touch a knob and then
adjust its value using the
2Mix LVL knob: Use these to adjust the level sent to
the stereo bus. Touch a knob and then adjust its
value using the
DATA
dial.
(
) keys to
(
) or
Ô
,
ANALOG OUTPUTS L/A
connectors.
dial.
DATA
Advertisement
Table of Contents
