Playback Settings (Play Setup); General Page; Control Page; Sync And Time Code Settings (Sync T/C) - Tascam HS-8 Owner's Manual

Playback settings (PLAY SETUP)

Use this screen to make settings related to playback.

GENERAL page

Play Mode
Set how the playback of takes is handled.
One Take: Only the currently selected take is played back.
All Take: All the takes in the currently loaded folder are
played back.
(Default setting: )
One Take
Repeat Mode
Turn repeat playback ON and OFF.
(Default setting: OFF)

CONTROL page

Auto Cue
Turn the auto cue function ON or OFF (Default setting:
OFF). If auto cue is ON, whenever a take is changed or
loaded, the unit will enter playback standby at the point
where sound first starts in the take.
If no sound is detected before the end of the take, the unit
pauses at the start of the take. To set the auto cue start
point detection level, touch the knob area and use the
DATA dial to change the value.
Options: –72 dB, –66 dB, –60 dB, –54 dB (default value),
–48 dB, –42 dB, –36 dB, –30 dB, –24 dB
Auto Ready
Turn the auto ready function ON or OFF. If auto ready
is ON, when playback of a take completes the unit
automatically stops a the beginning of the next take.
(Default setting: OFF)
6 – Internal Settings and Operations
Inc. Play
Turn the incremental play function ON or OFF. When
incremental play is ON, press the
playback to move to the beginning of the next take and
continue playing, or press the
playback to move to the beginning of the next take and
pause playback. (Default setting: OFF)

Sync and time code settings (SYNC T/C)

Use the
time code settings. This screen has five pages:
SYNC
the screen to open the corresponding page.

CLOCK page

View various clock status information and select the clock
used for synchronization.
STATUS
The top section shows the project sampling frequency
and the clock synchronization status.
The bottom section shows digital input signal status for
pairs of channels in the format
channels), as follows.
Digital input signal status
When locked
When sampling frequency
conversion (FSConvert) is
ON
When unlocked
When there is no signal
When there is no audio
signal
When Cbit information is
not professional
When other Cbit
information and the
actual operation mode are
different
STOP (RETAKE)
screen to make synchronization and
SYNC T/C
, , and . Touch the tabs at the bottom of
T/C SETUP I/O
CHx-xDIN
Locked (xx.xxx kHz)
Locked (xx.xxx kHz
FsCnv)
Unlocked (xx.xxx kHz)
Unlocked (No signal)
Not Audio
Not Professional
Unmatched Cbit
PLAY key during
key during
,
CLOCK
( shows the
x-x
Display
45
TASCAM HS-8