Troubleshooting - Waring WFP16SCDE Manual

• It is recommended that you plan your food preparation in a
manner that will allow for five minutes of grating, followed by
five minutes of food preparation while the machine rests.
• When grated food reaches nearly full capacity of the bowl,
remove all grated food from the bowl.

TROUBLESHOOTING

This section describes potential problems and the correct
solutions for them. Problems that cannot be solved with the
guidelines listed below should be referred to one of the Waring
Authorized Service Centers for assistance. A listing of authorized
service agencies is supplied with each Waring food processor.
Unit does not start when assembled correctly
• Pull the plug and try plugging into another outlet.
• Make sure the bowl is properly positioned on the motor base,
that the bowl cover is attached properly, and that the safety
interlock tab on the cover has properly engaged the safety
interlock switch.
• Press ON button.
Unit stops running during processing
• The unit may have overheated. Refer to Resetting Thermal
Protection section (page 14).
• Turn unit off and unplug.
• Remove bowl attachment.
• Remove food being processed from inside the bowl and
discard.
• Allow unit to cool for 30 minutes.
• Reassemble unit, and run first with the bowl empty, then put
food into the bowl and try again.
Unit jams or vibrates excessively
• Turn unit off and unplug.
• Disassemble the batch bowl/accessories.
• Make sure there is no food in S-blade hub (if applicable).
• Clean food off accessory discs (if applicable).
• Reassemble unit, and run first with the bowl empty, then put
food into the bowl and try again.
19