Table of Contents
Advertisement
REGULATORY INFORMATION
Chapter 5 – Regulatory Information
47 CFR Part 15 Regulation Class B Devices
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
FCC Interference Notice
Per FCC 15.19(a)(3) and (a)(4) This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC Grant
FCC Part 15C
FCC Identifier:
Equipment Class:
Notes:
FCC Rule Parts:
Approval:
FCC Rule Parts
15C
Single Modular Approval. Power output listed is conducted. This device is approved for mobile and fixed use with
respect to RF exposure compliance, and may only be marketed to OEM installers. The antenna(s) used for this
transmitter, as described in this filing, must be installed to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operate in conjunction with any other antenna or transmitter, except in
accordance with FCC multi-transmitter product procedures. Installers and end-users must be provided with
operating conditions for satisfying RF exposure compliance. Maximum permitted antenna gain/cable loss: 7 dBi.
16
AU792U21K16868
Digital Transmission System
MTAC-003U00
15C
Single Modular
Frequency Range
(MHz)
902-928
Output Watts
0.549
MTAC-003 Gateway Accessory Card Hardware Guide
Advertisement
Table of Contents
