Elite Fitness VO2 Assembly Manual page 10

STEP 3
Attach the Front Post.
— Remove the pre-assembled 6 Allen head bolts (44) and 2 curve washers (50) and
4 flat washer (51) from the main frame (1).
— Connect the middle section sensor wire (57) of the front post(2) and front cover(12)
with the lower section sensor wire (58) securely.
— Connect the tension cable (56) with lower tension cable (55). (See figure).
dial is set to '8' to allow for greater cable extension. The upper cable sheath end must be
securely inserted into the lower tension cable bracket.
— Put the front post (2) and front cover(12) into the bottom post of main frame (1) and fasten
with 6 Allen head bolts (44) , 2 curve washers (50) and flat washer(51).Please note don't
tighten all head bolts (44) too much at the beginning. When all parts are fixed already,
and then fasten each one piece tightly.
— Assemble each pedal (11R&11L) to the crank . Pedal "R" assemble with crank right side ,
Pedal "L" assemble with crank left side : See the mark "R" & "L"(right and left) on the
pedals (11R&11L) and crank .
NOTE: The right pedal "R" should be threaded on clockwise. The left pedal "L" should be threaded
on counter-clockwise.
— Attach the pedal straps to the pedals (11R&11L).
NOTE: Adjust the pedal straps to suit your foot/shoes size.
10
Ensure the tension
There are 4 adjustable positions.