TVS Stryker 3V 2021 Manual page 46

MAINTENANCE
FUSE
Non-working of electrical systems may be due to
safety fuse failure. Short circuit or overload in the
electrical system are the main causes for fuse failure.
Follow the procedure given below for inspecting and
replacing the fuse.
1. Open the cover frame L as explained earlier (refer
page no. 29).
2. The fuse case fitted near the battery contains one
10A and one 15A fuses with a spare.
3. Take out the fuse case from the battery band and
open its cover if electric start is not working please
check with whether 40A fuse is good or not. Pull
out the required fuse.
4. Inspect the fuse for failure. If found blown, replace
it with new one with the same rating (additional
fuses are provided inside the fuse case itself).
5. Close the fuse case and re-fix case into the battery
band.
6. Turn 'ON' the ignition switch and check for proper
functioning of electrical systems. Incase the fuse
fails again, consult the nearest TVS Motor
Company Authorised Distributor or Dealer /
Authorised Service Center.
Caution
Do not use vehicle by shorting the wires without
fuse. This may result in overheating of electrical items
/ wiring and may result in fire.
Do not use fuse of higher amperage than specified for
the safety of electrical system.
41