Table of Contents
Advertisement
32
Technical Manuals Online! - http://www.tech-man.com
Ademco Contact ID Format
If 'E' is entered for address 16, the following data is automatically programmed for the Primary
phone number event codes.
Enter a '000' for the data setting to disable the report.
Address
Description
69 - 71
Primary # General Alarm Code
72 - 74
Primary # Zone/Point Alarm Code
75 - 77
Primary # General Supervisory Code
78 - 80
Primary # Zone/Point Supervisory Code
81 - 83
Primary # General Fault Code
84 - 86
Primary # AC Fault Code
87 - 89
Primary # Zone/Point Fault Code
90 - 92
Primary # Low Battery Fault Code
93 - 95
Primary # Telco Primary Line Fault Code
96 - 98
Primary # Telco Secondary Line Fault Code
99 - 101
Primary # NAC Fault Code
102 - 104
Primary # Comm. Trouble Primary # Code
105 - 107
Primary # Comm. Trouble Secondary # Code
108 - 110
Primary # 485 Comm. Trouble Code
111 - 113
Primary # System Off Normal Code
114 - 116
Primary # UDACT-F Off Normal Code
117 - 119
Primary# System 24 Hour Test
120 - 122
Primary # System 24 Hour Test w/active event
123 - 125
Primary # Manual Test Message
Notes:
1) Note: Zero entries prevent the transmission of the report to the Central Station.
2) Refer to Contact ID program locations 64 - 68.
3) The identification of the zone/sensor number is automatically transmitted by the UDACT-F and is
added to the main event code. See Appendix A-3 for more information.
4) Factory default for this report is 110 (110 is transmitted for modules, however, 111 will
automatically be transmitted for smoke detectors). Use Type Mode (refer to Section 4.2) to change
this report per zone or point.
Table 3-4: Ademco Contact ID, Primary Number
Document # 50049 Rev D 5/2/97 P/N 50049:D
firealarmresources.com
1
Setting
Sensor Number
2
110
000
110
4
Note
3
200
000
2
3
200
Note
300
301
380
Note
3
302
351
352
321
354
354
300
308
350
602
608
601
Advertisement
Table of Contents
