Multifunction Lever; Daytime Running Lights (Drls); If Equipped; High/Low Beam Switch - Jeep GRAND CHEROKEE L 2021 Owner's Manual

56 GETTING TO KNOW YOUR VEHICLE
M L
ULTIFUNCTION EVER
The multifunction lever is located on the left side of
the steering column.

Multifunction Lever

D R L
AYTIME UNNING IGHTS
I E
F QUIPPED
The Daytime Running Lights (DRLs) come on
whenever the engine is running, and the low
beams are not on. The lights will remain on until
the ignition is placed in the OFF or ON/RUN
position, or the parking brake is engaged. The low
beams must be used for normal nighttime driving.
NOTE:
For vehicles sold in Canada, the Daytime

Running Lights will automatically deactivate
when the front fog lights are turned on.
If allowed by law in the country in which the

vehicle was purchased the Daytime Running
Lights can be turned on and off using the
Uconnect system
On some vehicles, the Daytime Running Lights

may deactivate, or reduce intensity, on one side
of the vehicle (when a turn signal is activated on
that side), or on both sides of the vehicle (when
the hazard warning lights are activated).
H /L
IGH OW
Push the multifunction lever toward the instrument
(DRL ) —
S
panel to switch the headlights to high beams.
Pulling the multifunction back toward the steering
wheel will turn the low beams back on, or shut the
high beams off.
A
UTOMATIC
I E
F QUIPPED
The Automatic High Beam Headlight system
provides increased forward lighting at night by
automating high beam control through the use of a
digital camera mounted on the inside rearview
mirror.
page 193.
Ú
B S
EAM WITCH
H B —
IGH EAMS
This camera detects vehicle specific light and
automatically switches from high beams to low
beams until the approaching vehicle is out of view.
NOTE:
The Automatic High Beam Headlight system can

be turned on or off by selecting or deselecting
"Auto High Beam" within Uconnect Settings
page 193.
Ú
The headlight switch must also be turned to the

AUTO position after Automatic High Beams is
enabled within Uconnect Settings for the
feature to activate.
Automatic High Beams will only activate when

the vehicle speed is above 22 mph (35 km/h).
Broken, muddy, or obstructed headlights and

taillights of vehicles in the field of view will
cause headlights to remain on longer (closer to
the vehicle). Also, dirt, film, and other obstruc-
tions on the windshield or camera lens will
cause the system to function improperly.
If the windshield or Automatic High Beam
Headlight Control mirror is replaced, the mirror
must be re-aimed to ensure proper performance.
See a local authorized dealer.