Air Suspension Modes - Jeep GRAND CHEROKEE WK 2022 Owner's Manual

104 STARTING AND OPERATING
AUTO and the vehicle level is either in Normal or
Aero. The vehicle will not automatically lower if the
air suspension level is in OR2 or OR1. If the vehicle
is equipped with Intrusion Theft Module (ITM), the
lowering will be suppressed when the ignition is
switched OFF to prevent setting the alarm off.
The Selec-Terrain system will automatically change
the vehicle to the proper height based on the
position of the Selec-Terrain switch. The height can
be changed from the default Selec-Terrain setting
by normal use of the air suspension buttons
Ú page 106.
The system requires that the engine be running for
all changes. When lowering the vehicle all of the
doors, including the liftgate, must be closed. If a
door is opened at any time while the vehicle is
lowering the change will not be completed until the
open door(s) is/are closed.
The Quadra-Lift air suspension system uses a
lifting and lowering pattern which keeps the
headlights from incorrectly shining into oncoming
traffic. When raising the vehicle, the rear of the
vehicle will move up first and then the front. When
lowering the vehicle, the front will move down first
and then the rear.
After the engine is turned off, it may be noticed that
the air suspension system operates briefly; this is
normal. The system is correcting the position of the
vehicle to ensure a proper appearance.
To assist with changing a spare tire, the
Quadra-Lift air suspension system has a feature
which allows the automatic leveling to be disabled
Ú page 152.
NOTE:
If equipped with a touchscreen radio, all enabling/
disabling of air suspension features must be done
through the radio Ú page 152.
WARNING!
The air suspension system uses a high pressure
volume of air to operate the system. To avoid
personal injury or damage to the system, see an
authorized dealer for service.
A S M
IR USPENSION ODES
The Air Suspension system has multiple modes to
protect the system in unique situations:
Tire/Jack Mode
To assist with changing a spare tire or setting up
trailer weight distribution bars, the air suspension
system has a feature which allows the automatic
leveling to be disabled Ú page 152.
NOTE:
This mode is intended to be enabled with the
engine running.
Auto Entry/Exit Mode
To assist in entering and exiting the vehicle, the air
suspension system has a feature which
automatically lowers the vehicle to Entry/Exit ride
height Ú page 152.
NOTE:
This mode is intended to be enabled with the
engine running.
Transport Mode
To assist with flat bed towing, the air suspension
system has a feature which will put the vehicle into
Entry/Exit height and disable the automatic load
leveling system Ú page 152.
NOTE:
This mode is intended to be enabled with the
engine running.
Suspension Display Messages Mode
The Suspension Display Messages setting allows
you to only display suspension warnings
Ú page 152.
NOTE:
This mode is intended to be enabled with the
engine running.