Table of Contents
Advertisement
7. Turn the low or high beam bulb a quarter turn
counterclockwise to remove from housing.
8. Disconnect the electrical connector and
replace the bulb.
FRONT TURN SIGNAL LAMP — IF EQUIPPED
See the following steps to replace:
1. Open the hood.
2. Access the back of the headlamp.
3. The air filter housing must be removed.
4. The windshield washer reservoir may need to
be rotated out of the way by removing the
fastener.
5. Coolant reservoir (if equipped) will need to be
repositioned by removing the fasteners, and
moving the unit out of the way.
6. Turn the turn signal bulb a quarter turn
counterclockwise to remove from housing.
7. Disconnect the electrical connector and
replace the bulb.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If
the bulb comes in contact with any oily surface,
clean the bulb with rubbing alcohol.
FRONT FOG LAMPS
Please see an authorized dealer for service on LED
and Halogen front fog lamps.
REAR TAIL, STOP, AND TURN SIGNAL LAMPS —
IF EQUIPPED
See the following steps to replace:
1. Raise the liftgate.
2. Remove the two push-pins from the tail lamp
housing.
Tail Lamp Push Pins
SERVICING AND MAINTENANCE
3. Grab the tail lamp and pull firmly rearward to
disengage the lamp from the aperture panel.
4. Twist socket counterclockwise and remove
from lamp.
Rear Of Tail Lamp
1 — Rear Turn/Stop Bulb Socket
2 — LED Tail Connector – Do Not Remove
3 — Backup Bulb Socket
5. Pull the bulb to remove it from the socket.
6. Replace the bulb, reinstall the socket, and
reattach the lamp assembly.
281
8
Advertisement
Table of Contents
