Environmental Conditions; Regulatory Markings; Waste Electrical And Electronic Equipment (Weee) Directive - ITech IT8722 Manual

Environmental Conditions

The instrument is designed for indoor use and an area with low condensation.
The table below shows the general environmental requirements for the
instrument. The speed of fan will change intelligently by the temperature of
radiator. When the temperature is up to 40°C, the fan will be on and adjust
intelligently when temperature changes.
Environmental Conditions
Operating temperature
Operating humidity
Storage temperature
Altitude
Pollution degree
Installation category

Regulatory Markings

Waste Electrical and Electronic Equipment (WEEE)
Directive
Note
To make accurate measurements, allow the instrument to warm up for 30 min before
operation.
2002/96/EC Waste Electrical and Electronic Equipment
(WEEE) Directive
This product complies with the WEEE Directive (2002/96/EC)
marking requirement. This affix product label indicates that you
must not discard the electrical/electronic product in domestic
household waste.
Product Category
Copyright © Itech Electronic Co., Ltd.
Requirements
0°C to 40°C
20%-80% (non-condensation)
-20°C to 70 °C
Operating up to 2,000 meters
Pollution degree 2
II
The CE mark indicates that the product
complies with all the relevant European
legal directives. The specific year (if any)
affixed refers to the year when the design
was approved.
The instrument complies with the WEEE
Directive (2002/96/EC)
requirement. This affixed product label
indicates that you must not discard the
electrical/electronic product in domestic
household waste.
This symbol indicates the time period
during which no hazardous or toxic
substances are expected to leak or
deteriorate during normal
expected service life of the product is 10
years. The product can be used safely
during the 10-year Environment Friendly
Use Period (EFUP). Upon expiration of
the EFUP, the product
immediately recycled.
IT8700 User Manual
marking
use. The
must be
iii