Table of Contents
Advertisement
L2 Managed Switch
Chapter 4 Connection
13
Connection
Downloaded from
ManualsNet.com
4.1 Ethernet Port
Connect the Ethernet ports of the switch to the network devices by RJ45 cable as the
following figure shows.
RJ45 Port
4.2 SFP Port
Connect the SFP port to an SFP module. For the switch, if an SFP transceiver (purchased
separately) is installed in a slot and has a valid link on the port, the associated RJ45
port will be disabled and cannot be used.
4.3 Console Port
CLI (Command Line Interface) enables you to manage the switch, thus you can load
the CLI after connecting the PCs or Terminals to the console port on the switch via the
provided cable.
Connect the console port of the device with your computer by the console cable as the
following figure shows.
search engine
Figure 4-1 Connecting the RJ45 Port
Figure 4-2 Inserting the SFP Module
RJ45 Cable
SFP Port
SFP Module
Advertisement
Table of Contents
