Keyestudio 4WD Manual page 263

www.keyestudio.com
Enter"Advanced"→"Serial"→
Leave it into"forever"block.
Go to"Pins"→"digital read pin P0 "
Move"digital read pin P0"into 0 box
The right tracking sensor is controlled by P14. Then change P0 into P14
and"x"into"digital signal".
(2) Click " Advanced " → " Serial " to find and drag
"forever";
input"left:"
Click " MecanumRobot " to find and drag
to
Copy
and drag it again;
;
once and change "left:" to " right:"
;
t
263