(1)
Change the angle of the Top Output Tray to the lower
fixed position (A).
(2)
Install the wires on the extension trays.
Note
As holding the extension tray with a hand, insert the fixing devices
firmly, and check that the wires will not come off from the exten-
sion tray.
(3)
Adjust the wire positions as aligning the wires with the
"" marks.
■ When not using the kit
Store the kit in the storage case at the rear side of Finisher.
Paper Curl
• If A5
is curled upward, a paper jam may occur.
For Interface Module, set the upward curl correction of Interface Module.
For Interface Decurler Module + Inserter, set the highest curl correction of Interface Decurler
Module and upward curl correction of Inserter.
• If thick paper is curled downward, a paper jam may occur.
For Interface Module, set the downward curl correction of Interface Module.
For Interface Decurler Module + Inserter, set the lowest curl correction of Interface Decurler
Module and downward curl correction of Inserter.
• If paper of 157 g/m
For Interface Module, set the upward curl correction of Interface Module.
For Interface Decurler Module + Inserter, set the highest curl correction of Interface Decurler
Module and upward curl correction of Inserter.
Refer
"Curl Correction" (p.26)
56
Optional Units
2
or more is curled upward, a paper jam may occur.