FujiFilm Apeos C8180 Reference Manual page 54

Outputting Paper
Top Output Tray
Loading Guide
Place it on the Top Output Tray when using an envelope.
Changing Angle
Change the angle when output paper remains at the exit and paper full is detected immediately.
Especially in the following case, paper full is likely to be detected, change the angle to the B posi-
tion.
• Thin coated paper
• Coated paper with the length of 364 mm or more
• Long paper
Pull the Top Output Tray to the right, remove it from the
lower fixed position (A), and insert the claws at the front
edge of the tray to the upper fixed position (B).
Note
• Normally set the tray at the lower fixed position.
If the tray is at the upper fixed position of the exit, paper may fall
from the Top Output Tray and a paper jam may occur when paper
is output to the Finisher tray.
• If paper is curled, the effectiveness of angle change cannot be ob-
tained.
54
Optional Units
A B