Table of Contents
Advertisement
About this task
The following image indicates the location of the Dell Ultra Speed Drive Gen 4 card and provides a visual representation of the
installation procedure.
Steps
1.
NOTE:
The Dell Ultra Speed Drive Gen4 card must be installed in the PCIe x4 slot.
Align the Dell Ultra Speed Drive Gen 4 card with the PCIe x4 card slot on the system board.
2. Using the alignment post, connect the card in the connector and press down firmly.
3. Ensure that the card is firmly seated.
4. Close the expansion-card door, and press until it clicks into place.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Optional I/O modules (PS2/Serial)
Removing optional PS2 module
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
front
bezel.
4. Remove the
heat-sink and fan
About this task
The following images indicate the location of the optional PS2 module and provides a visual representation of the removal
procedure.
after working inside your
before working inside your
assembly.
computer.
computer.
Removing and installing components
67
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiPlex 5000 Small Form Factor and is the answer not in the manual?