Optional I/O Modules (Ps2/Serial); Removing Optional Ps2 Module - Dell D17S Service Manual

Steps
1. Place the SD-card reader onto the connector on the system board.
2. Install the two screws (M3x5) that secure the SD-card bracket to the system board and computer.
3. Reroute the cables through the routing guides on the SD-card reader bracket.
Next steps
1. Install the hard-drive and optical-drive
2. Install the 3.5-inch hard-drive.
3. Install the 2.5-inch hard-drive.
4. Install the front bezel.
5. Install the side cover.
6. Follow the procedure in

Optional I/O modules (PS2/Serial)

Removing optional PS2 module

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the heat-sink and fan
About this task
The following images indicate the location of the optional PS2 module and provides a visual representation of the removal
procedure.
cage.
after working inside your
before working inside your
assembly.
computer.
computer.
Removing and installing components 71