Table of Contents
Advertisement
Steps
1. Remove the two (#6-32) screws that secures the bracket to the chassis.
2. Push the bracket to free it from the front side of the chassis.
3. Lift and remove the bracket from the system.
Installing the hard-drive and optical-drive supporting bracket
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the hard-drive and optical-drive supporting bracket and provides a visual
representation of the installation procedure.
40
Removing and installing components
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiPlex 5000 Small Form Factor and is the answer not in the manual?
Questions and answers