Table of Contents
Advertisement
About this task
The following images indicate the location of the speaker and provide a visual representation of the removal procedure.
Steps
1. Disconnect the speaker cable from the connector on the system board.
2. Press the tab and slide the speaker along with the cable from the slot on the chassis.
Installing the speaker
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speaker and provides a visual representation of the installation procedure.
74
Removing and installing components
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiPlex 5000 Small Form Factor and is the answer not in the manual?
Questions and answers