Table of Contents
Advertisement
Steps
1. Loosen the four captive screws that secure the voltage-regulator heat sink to the system board.
2. Lift the voltage-regulator heat sink off the system board.
Installing the voltage-regulator heat sink
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the voltage-regulator heat sink and provide a visual representation of the
installation procedure.
Steps
1. Place the voltage-regulator heat sink on the system board.
2. Align the captive screws on the voltage-regulator heat sink to the screw holes on the system board.
3. Tighten the four captive screws that secure the voltage-regulator heat stink to the system board.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
after working inside your
computer.
60
Removing and installing components
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiPlex 5000 Small Form Factor and is the answer not in the manual?
Questions and answers