Daewoo Lanos 2002 Owner's Manual page 105

WHEEL CHANGING
In order to reduce the chance of possible
injuries when changing a wheel, note the
following procedure and observe all refer-
ences:
• Move cautiously off the road to a safe
place away from the traffic.
• Park on a firm and level surface.
• Turn the ignition switch off and remove
the ignition key.
• Switch on the hazard warning flashers
and apply the parking brake firmly. Place
the automatic transmission selector le-
ver in position "P", or with manual trans-
mission engage first gear or reverse.
• Block the wheel diagonally opposite the
wheel to be changed by placing wedge
blocks or any available blocks of wood
or rocks behind and in front of it.
• Set up warning triangle.
• Have all passengers get out of the car
and stand in a safe place away from the
traffic and clear of the vehicle.
Procedures
1. Pry the wheel cover off with the lug
wrench or flat head screwdriver.
2. Loosen the wheel bolts one turn each
with the wheel wrench, but do not re-
move any bolts until the wheel has been
raised off the ground.
3. Lift the jack handle away from the jack
base and raise to vertical position. Ro-
tate the jack handle clockwise to raise
the lift head slightly.
2
3
4
1
Loosen
IN CASE OF EMERGENCY 6–3
4. At the front and rear there are recesses
for inserting the vehicle jack. The jack
location is marked by half circle cut outs.
Place the jack vertically at the front or
rear jacking location closest to the wheel
you are changing.