Canon iR1510 Reference Manual page 31

4
n n n n Specifying the Paper Size (Stack Bypass)
At the factory the paper size has already been set to
when the copy images or the back of the paper is dirty, you can prevent the paper from getting dirty by specifying the paper size
according to the following.
• To set the
A D D I T I O N A L F U N C T I O N S
- Specifying the paper size every time you load the paper: Select
A D D I T I O N A L F U N C T I O N S
- Set to the fixed paper size: Select
set to , then select the paper size appropriately from
O N
* When
C U S T O M P A P E R S I Z E
Available setting range in length: 127 mm to 356 mm
Available setting range in width : 76 mm to 216 mm
n n n n Specifying the Paper Type (Stack Bypass)
is selected as the default paper type. When making copies on other paper than plain paper, you can specify the
P L A I N P A P E R
paper type according to the following. Specifying the paper type can prevent poor copy quality, or the copy image not being
printed correctly.
• To set the
A D D I T I O N A L F U N C T I O N S
Select
B Y P A S S P A P E R T Y P E
following.
-
P L A I N P A P E R
-
T R A C I N G P A P E R
-
T R A N S P A R E N C Y
-
S P E C I A L P A P E R 1
-
S P E C I A L P A P E R 2
* If the images are dirty, even in the settings above when making copies on thick paper set as follows: Select
of
L E V E L C O M M O N S E T T I N G S
F R E E S I Z E
, see "Accessing the Additional Functions". (→ p. 7-1)
and set to , then set to
O F F
S T A C K B Y P A S S S I Z E
is selected, specify the width and length of the paper in millimeter (mm).
, see "Accessing the Additional Functions". (→ p. 7-1)
of
C O M M O N S E T T I N G S
2
: Plain paper (80 g/m )
: Thin paper, tracing paper (56 - 63 g/m
: Transparencies
: Heavy paper* (81 - 128 g/m
: Envelopes
in the
A D D I T I O N A L F U N C T I O N S
. Normally, you can make copies in this setting. However,
S T A C K B Y P A S S S I Z E
.
S E T O N L O A D I N G
of
C O M M O N S E T T I N G S
, , , , ,
A 4 B 5 A 5 L G L L T R S T M T
in the
A D D I T I O N A L F U N C T I O N S
2
)
2
)
, and set to
of
C O M M O N S E T T I N G S
in the
A D D I T I O N A L F U N C T I O N S
or
C U S T O M P A P E R S I Z E
and select the paper type from the
C O P Y P O W E R
.
H I G H
in the
and
* .
4
4-3