Device Variables; Power Supply Units - Omron SYSMAC-SE2 Series Practices Manual

3 Setting EPLAN Electric P8
Precautions for Correct Use
To import a CJ-series Unit configuration, you need to set this as follows.
• Set slot numbers so that they do not conflict in the Expansion Rack configuration.
• Set slot numbers so that they are sequential numbers that start from 0.
• Set slot numbers so that they are not more than the maximum unit number of the CPU Rack
for NJ-series CPU Units.
3-3-5

Device Variables

Set the component data for models that support the connector function for device variables as follows.
 PLC Connection Points
Set the target I/O ports as follows.
ID
20402
20011
Precautions for Correct Use
• To enter a device variable comment, you need to set the device variable name.
• Set device variable names so that they do not conflict in the controller configuration. Device
variables with conflicting variable names will not be imported.
• When ID: 20438 Deactivated I/O connection point is selected, device variables will not be im-
ported to the Sysmac Studio even if their device variable names and device variable com-
ments are entered.
3-3-6

Power Supply Units

 PLC Box
Leave all the setting values of the PLC box blank.
ID
20161
20408
20427
20410
20411
20253 1
3-14
Sysmac Studio Electrical CAD Connector Function Practices Guide for AutomationML Import (EPLAN Electric P8) (P156)
Property name
Symbolic address
Function text
Property name
Configuration project
Station ID
Rack ID
PLC card is placed on rack ID
Position (slot / module)
CPU: Name [1]
Setting value
Device variable name
Device variable comment
Setting value
Blank
Blank
Blank
Blank
Blank
Blank