Nx Units - Omron SYSMAC-SE2 Series Practices Manual

3 Setting EPLAN Electric P8
Six-port Junction Slaves
 PLC Box
Set the PLC box as follows.
ID
20161
20408
20253 1
20418
 Bus Ports (EtherCAT Ports)
Set the EtherCAT ports as follows.
ID
20311
(a)
GX-JC06
Precautions for Correct Use
To import EtherCAT slaves, you need to set this as follows.
• Place the EtherCAT slaves in the Schematic single-line page.
• Set the node addresses so that they do not conflict with other slaves.
3-3-3

NX Units

Set the component data for NX Units as follows.
3-10
Sysmac Studio Electrical CAD Connector Function Practices Guide for AutomationML Import (EPLAN Electric P8) (P156)
Property name
Configuration project
Station ID
CPU: Name [1]
Version
Property name
Physical network: Bus ID /
item number
(b)
Setting value
Same value as "Configuration project" of the CPU Unit
Any name in a format that meets the EPLAN specification con-
straints and is different from "Station ID" of other component
data
Same value as "CPU: Name [1]" of the CPU Unit
Revision of the EtherCAT slave (This must be a version that
exists in the Sysmac Studio and a single-byte number that con-
tains periods as the delimiter.)
If blank, the component data will be imported with the latest
version.
Setting value
(a): Node address on the input, X2, or X3 side (Set a single-
byte number within the node address range of the CPU Unit
that can be set.)
(b): Node address on the X4, X5, or X6 side (Set a single-byte
number within the node address range of the CPU Unit that
can be set.)