Setting Component Data; Cpu Units; Ethercat Slaves - Omron SYSMAC-SE2 Series Practices Manual

3-2

Setting Component Data

This section describes, for each target data, the setting rules for component data in EPLAN Electric
P8, which are necessary for the connector function.
For OMRON devices that support the connector function, EPLAN Data Portal provides component da-
ta that complies with the rules (component data as of June 2022 or later).
3-2-1

CPU Units

Set the component data for CPU Units as follows.
 PLC Box
Set the PLC box as follows.
ID
20416 PLC type designation
20427 Rack ID
20167 CPU
20164 Bus coupler / head station
 Bus Ports (EtherCAT Ports)
Set the PLC connection points of the built-in EtherCAT port as follows.
ID
20026 Function definition
20308 Bus system
20447 Bus interface: Name
20310 Logical network: Bus port is master
20448 Bus interface: Main bus port
3-2-2

EtherCAT Slaves

Set the component data for EtherCAT slaves as follows.
EtherCAT Slaves (Excluding Junction Slaves)
 PLC Box
Set the PLC box as follows.
ID
20416 PLC type designation
20427 Rack ID
20167 CPU
20164 Bus coupler / head station
Sysmac Studio Electrical CAD Connector Function Practices Guide for AutomationML Import (EPLAN Electric P8) (P156)
Property name
Property name
Property name
3 Setting EPLAN Electric P8
Setting value
Model name of the CPU Unit
Example: "NJ101-9000"
0
Selected.
Selected.
Setting value
Network / bus cable connection, general
EtherCAT
EtherCAT
Selected.
Selected.
Setting value
Model name of the EtherCAT slave
Example: "NX-ECC203"
0
Not selected.
Selected.
3
3-3