Table of Contents
Advertisement
when a user touches the push buttons (
buttons and scroll wheel are copper pads created inside the PCB. Touch
the respective push button or traverse around the scroll wheel with a fin-
ger to enable the sensor pads and to generate the interrupt request. The
IRQ line connects the AD7147 controller to the processor via its GPIO
pin. By default, the AD7147 controller uses the SPI select 2 and
pins.
"Jumper Settings" on page 2-3
selects can be varied for different EZ-KIT Lites and EZ-Boards.
For more information about the AD7147 touch controller, go to
www.analog.com
An example program demonstrating capabilities of the touch controller is
available in the
Serial ROM
The Blackfin Landscape LCD EZ-Extender is equipped with a 2 KB serial
ROM device (M24C02) for revision and configuration control: bill of
materials and PCB revision information is available by reading the ROM.
The part connects to the Blackfin processor via the processor's TWI inter-
face. By default, the serial ROM is read-only to protect the internally
stored contents. On the extender, the last three significant TWI address
bits are strapped to logic '
TWI address bits, use the provided jumpers; see
page 2-3
for more information.
For more information on the M24C02 device, go to the STMicroelectron-
ics Web site.
More information on the revision and configuration control is available in
the
folder of the installation directory.
Examples
Blackfin Landscape LCD EZ-Extender Manual
Landscape LCD EZ-Extender Interfaces
and search for
AD7147
folder of the installation directory.
Examples
' (default). To modify the last three significant
0
) or scroll wheel. The push
PB1—4
describe how the GPIO and SPI
.
"Jumper Settings" on
GPIO2
1-5
Advertisement
Table of Contents
