Olympus DP74 Instructions Manual page 17

8. If the camera or microscope is vibrated during image acquisition in 3CMOS mode (5760 x 3600 / 2880 x 1800 /
1920 x 1200 pixels), the image may be disturbed. The several causes for the vibration are, operation of keyboard
and mouse on the same table where the microscope equipped with the camera is placed, vibration from the
equipment with built-in air cooling fan placed on the same table as microscope, etc.
9. If the resolution of the live image is different from the resolution of the image to be acquired, intended images may
not be obtained.
10. The maximum speed of the frame rate of the live image may not be secured depending on the graphic card type
to be used.
11. If you insert the high reflectance filter (45LBD-IF, etc.) in the filter holder of the microscope, the flare may be
noticeable.
The flare becomes less noticeable if you place the ND filter for transmitted light illumination or low reflectance type
(45-ND25, etc.) on the condenser side of the high reflectance filter.
12. If the color of the illumination is disproportionate significantly (Ex.: low color rendering LED illumination), the white
balance may not be obtained.
13. When you move the specimen (stage), an afterimage or the area viewed in black may be noticeable on the live
image due to the influence of the live noise reduction function.
14. When you move the specimen (stage), the afterimage may be noticeable on the live image due to the influence of
the HDR function.
DP74
13