Installation; Environment Of Use - AGFA XD 14 User Manual

38 | XD 14, XD⁺14 | Introduction to the DR Detector

Installation

Installation and configuration is performed by an Agfa trained and authorized
service engineer. Contact your local support organization for more
information.
On a configuration with multiple DR detectors of the same type, it is required
to apply labeling to the DR detector containing a unique nickname for each
DR detector. The nicknames must be configured on the MUSICA Acquisition
Workstation. The DR Detector Switch shows which DR detector is active and
shows its status, by means of the nickname of the DR detector.
An identical label is attached to the bucky of the X-ray system to identify the
dedicated workspace of each DR detector.

Environment of Use

The equipment is mainly for use in X-ray exposure rooms, hospital wards and
mobile medical examination vehicles. To use it in other places, consult your
sales representative or local Agfa dealer.
• Close to facilities where water is used
• Where it will be exposed to direct sunlight
• Close to the air outlet of an air-conditioner or ventilation equipment
• Close to a heat source such as a heater
• Where the power supply is unstable
• In a dusty environment
• In a saline or sulfurous environment
• Where temperature or humidity is high
• Where there is freezing or condensation
• In areas prone to vibration
• On an incline or in an unstable area
Do not use the detector near devices generating a strong magnetic field. Doing
so may produce image noise or artifacts.
0430A EN 20210426 1355
WARNING:
Do not install or store the equipment in any of the locations
listed below. Doing so may result in failure or malfunction,
equipment falling, or fire or injury:
WARNING:
This product may malfunction due to electromagnetic
interference (EMI) caused by telecommunication devices,
transceivers, electronic devices, etc. To prevent the
electromagnetic wave from badly influencing the product, be
sure to avoid placing it near the product. Or, change direction or
position of the product or move into the shielded place to reduce
electromagnetic interference.