Wireless Communication - AGFA XD 14 User Manual

36 | XD 14, XD⁺14 | Introduction to the DR Detector

Wireless Communication

Wireless communication is established between the internal wireless module
of the DR detector and the MUSICA Acquisition Workstation via the wireless
access point. The DR detector is compliant with IEEE 802.11n/ac (2.4 GHz/5
GHz). The available frequency band varies depending on local radio laws and
system requirements. The frequency band (channel) of the DR detector is
selected at installation.
Wireless communication in the bucky
If the DR detector is configured in access point mode, the properties of
wireless communication, such as the throughput and operable distance, may
decrease if the DR detector is in the bucky.
For applications using the bucky, it is strongly recommended to install an
external access point.
0430A EN 20210426 1355
Note: Use of multiple pieces of equipment that use the same
frequency band (channel) may interfere with each wireless
communication and cause a decline in transmission speed.
Note: Before introducing other wireless equipment to the same
environment where the DR detector is set up, consult the system
engineer or qualified personnel at the medical site.
Note: Do not place obstacles in the way of the wireless access point
or of the antenna of the internal wireless module of the DR detector.
Otherwise, the properties of wireless communication, such as the
throughput and operable distance, may decrease.
Note: Transmitting the image data to the MUSICA Acquisition
Workstation takes a number of seconds. After making an exposure,
stay with the detector in the direct neighbourhood of the wireless
access point until the image is available on the MUSICA Acquisition
Workstation.