Waeco AirCon Service 6300G Operating Manual page 20

English
9. Create the four-digit personal user code. Once a code is created here, the A/C service unit can then only be
operated using this code.
ADM AREA
User number
Insert new code
10. 10. Confirm the new user code:
ADM AREA
User number
Confirm new code
Note To switch between upper and lower case use the yellow Info key.
11. Enter the user name and press ENTER to confirm:
ADM AREA
User number
User name
John Citizen
ADM AREA
User number
John Citizen
The user is created and the menu changes again to the user selection.
12. Proceed as follows:
• Create another user by using the cursor keys to select Database and proceed as described.
• To exit the menu press STOP.
13.3.2 Entering user codes
If a user code has been created, the same code must be used to enable the A/C service unit.
Enter the user code.
ENTER USER CODE
If you enter an incorrect user code, the following error message appears:
WRONG CODE
Once the correct code is entered, the A/C service unit is enabled and starts up. The user's name is dis-
played:
John Citizen
18
1
----
1
----
1
1
----